Senin, 29 September 2014

Then the material was put

Then the material was put into sterile wisata pulau pari plastic pressed-press while little by little, to note that the materials should be included as dense as possible to optimize the results. The more dense material in a plastic bag so the more oyster mushroom production, to be sure that the entry materials must be completely solid. Add ring PVC or bamboo strips on top of the plastic bag before finally closed using a plug of cotton and tied with a heat-resistant rubber. How to install PVC rings or pieces of bamboo in cultivation this is by installing PVC or bamboo strips on top of the plastic, and enter all parts of the tip into the hole peralon plastic or bamboo strips, pull firmly and then fold the ends of the plastic that has been entered into the hole PVC or bamboo pieces towards the outer side. After that, with strong plastic tie. As an illustration, the BUAHPOKER.COM AGEN POKER DOMINO ONLINE UANG ASLI INDONESIA TERPERCAYA TANPA ROBOT end result of the process of how to install the gutter or bamboo pieces are the end there is a hole baglog peralon or bamboo strips as the emergence of oyster mushrooms.

After sterilization of materials, process media sterilization is sterilization baglog next planting. Sterilization baglog on cultivation can be done by two methods: sterilization using an autoclave or heating baglog / Steamer and sterilization using oil drums. Method of sterilization can be adapted conditions, respectively, each method has its advantages and its own drawbacks. In principle, two ways this can create an environment conducive to the growth of oyster mushroom.

0 komentar:

Posting Komentar